Pitney Bowes ADDRESSRIGHT DA300 Operator's Manual page 34

Setting Up A
Job
(continued)
DA300 Printer Operator Guide
1. Set the Separator Gap (continued)
H-Block Separator
Lock Knob
Rear Wall
Place a
sample piece
against the
rear wall and
between the
separator
fingers and the
feed roller
Setup Example Using #10 Envelopes:
When you set the feed gap for a #10 envelope, the width
of the envelope will fall completely under the inside and
middle H-Blocks, but only half way under the outer H-
Block.
In this case, place a second envelope next to the first,
under the outer H-Block. Place the second envelope flap
down with the short edge under the outer H-Block.
(Before you do this, remove the sliding fence in order to
fit the second envelope under the outer H-Block). Lock
the separator in place.
DA300 Basics • 3
3-7