Overview - Omron WS02-CFSC1-E Operation Manual

Table of Contents

Overview

3-1

Note

This section describes how to debug using the Logic Window.

The Logic Window displays the Logic Program. Input tags can be modified

using the Logic Window, Tag List Window, or the Watch Window. The corre-

sponding outputs can then be verified. Similar to the Online Monitor Screen

for the Logic Editor of the Network Configurator, tags that are ON and lines

that are connected are displayed in dark green.

The Timing Chart Window and the Logic Window cannot be used for debug-

ging simultaneously.

A program simulation using an AND function block is shown as an example

below.

Input 1 is ON and input 2 is OFF. Therefore the output (output 1) of the AND

function block is OFF.

Note Tags that are ON and lines that are connected are displayed in dark

green.

Now, input 2 is modified by right-clicking it and selecting Set from the pop-up

menu.

As shown below, input 1 and input 2 turn ON and the AND function block out-

put (output 1) turns ON.

Section 3-1

Table of Contents

Table of Contents