Importing Programs - Omron WS02-CFSC1-E Operation Manual

Importing Programs

2-11 Importing Programs

1,2,3...
Note
To load programs from other simulation files, use the program import function.
The program import function only loads the program part of the file; informa-
tion in the Timing Chart Window and Watch Window will not be changed.
1. Select File - Import Program.
The following dialog box will be displayed.
2. Select a Simulation File and click the Open Button.
If there is a password setting on the program in the imported simulation file,
the following Confirm Password Dialog Box will be displayed.
3. Enter the Password and click the OK button.
Note If there is no password setting, the Confirm Password Dialog Box
will not be displayed.
The program part of the simulation file will be loaded and the logic program
will be displayed on the screen.
(1) After importing the program, if the tags and function blocks used in the
Timing Chart Window and Watch Window are not used within the import-
ed program, their names will appears as "???". Check these tags to see
if they are required. If they are not required, delete them. The original
names can be displayed again by importing the original program.
(2) To correct a program from a file that is being used in a simulation, edit the
program with the Network Configurator and then create a new simulation
file. Save the new file with a different name to that of the file being used
in the simulation, then import the program from that file. Files can be over-
written while the Logic Simulator is being used but any data other than
the program (i.e., information on the Timing Chart Window and Watch
Window) will all be deleted.
Section 2-11
19