Opening And Closing The Sunny Sensorbox; Opening The Sunny Sensorbox; Closing The Sunny Sensorbox - SMA SUNNY SENSORBOX Installation Manual

Opening and closing the Sunny SensorBox

8 Opening and closing the Sunny SensorBox
8.1 Opening the Sunny SensorBox
1. Using the notches as a guide, open the side flaps of
the Sunny SensorBox.
2. Loosen the screws in the corners of the Sunny
SensorBox.
3. Open the enclosure lid up towards the left. The lid is
connected to the lower shell by hooks.
☑ The Sunny SensorBox is open.
8.2 Closing the Sunny SensorBox
1. Check the sealing of the Sunny SensorBox enclosure before closing the lid on the lower
enclosure shell. If the sealing of the enclosure has become porous over time, make sure you
replace the enclosure gaskets (see section 9.4 "Replacing the gaskets of the Sunny SensorBox"
(page 68)).
2. Close the lid of the Sunny SensorBox on the lower enclosure shell.
3. Initially turn the screws of the enclosure lid a little to the left, until the screws fall into the first turn
of the thread.
4. Insert screws into the lower enclosure shell and tighten with a torque of 9 in‑lbs. (1 Nm).
5. Close the side flaps of the Sunny SensorBox.
☑ The Sunny SensorBox is closed.
66 Sensorbox-eng-IA-IUS-112515
SMA America, LLC
Installation Manual