SMA SUNNY SENSORBOX Installation Manual page 37

SMA America, LLC
Layout of the switch positions
NetID
0
1
(Status upon delivery)
2 - F
3. Connect the SMA Power Injector with Bluetooth to the power supply (see section
7.6.4 "Connecting the SMA Power Injector with Bluetooth to the power supply" (page 63)).
☑ The SMA Power Injector with Bluetooth shows the connection quality to the next available
SMA Bluetooth device. You can change the connection quality by moving the Bluetooth
devices further apart or shifting their orientation. The connection quality must be rated as
"good" or higher for the selected mounting/installation location (at least two yellow
Bluetooth LEDs glow).
– You must improve any connection that proves to be unreliable or too slow (see section
5.3.2 "LEDs indicating connection quality (Bluetooth LEDs)" (page 22)).
4. Disconnect the power and turn the rotary switch to "MODE 0".
☑ The mounting/installation location for the SMA Power Injector with Bluetooth has been
determined.
Once you have determined the best mounting location, you can mount the SMA Power Injector with
Bluetooth on a wall or top hat rail.
Installation Manual
Function
Bluetooth is switched off.
The three yellow Bluetooth LEDs flash.
Bluetooth is switched on.
The SMA Power Injector with Bluetooth can accept not more than two
connections from a communication product such as a Bluetooth-
enabled computer running Sunny Explorer or Sunny WebBox with
Bluetooth. A connection to the Sunny Beam with Bluetooth is not
possible.
The three yellow Bluetooth LEDs flash.
Bluetooth is switched on.
The SMA Power Injector with Bluetooth can network with all SMA
Bluetooth products that share the same NetID. A connection to the
Sunny Beam with Bluetooth is not possible.
Mounting the device
Sensorbox-eng-IA-IUS-112515 37