Viewing The Status Of Ethernet Ports; Section 3.6.2, "Viewing The Status Of Ethernet Ports - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
IMPORTANT!
If both link partners have the LFI feature, it must not be enabled on both sides of the link. If it is
enabled on both sides, the link will never be established, as each link partner will be waiting for the
other to transmit a link signal.
The switch can also be configured to flush the MAC address table for the controller port. Frames destined for the
controller will be flooded to Switch B where they will be forwarded to the controller (after the controller transmits
its first frame).
Section 3.6.2

Viewing the Status of Ethernet Ports

To view the current status of each Ethernet port, navigate to Ethernet Ports » View Port Status . The Port Status
table appears.
Figure 21: Port Status Table
This table displays the following information:
Parameter
Port
Name
Link
Speed
Duplex
Viewing the Status of Ethernet Ports
Description
Synopsis: 1 to maximum port number
The port number as seen on the front plate silkscreen of the switch.
Synopsis: Any 15 characters
A descriptive name that may be used to identify the device conected
on that port.
Synopsis: { ----, ----, Down, Up }
The port's link status.
Synopsis: { ---, 10M, 100M, 1G, 10G }
The port's current speed.
Synopsis: { ----, Half, Full }
The port's current duplex status.
Chapter 3
Device Management
67