Deleting A Remote Syslog Server - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 3
Device Management
Parameter
Facility
Severity
4. Click Apply.
Section 3.5.4.4

Deleting a Remote Syslog Server

To delete a remote syslog server from the list of known servers, do the following:
Navigate to Administration » Configure Syslog » Configure Remote Syslog Server . The Remote Syslog
1.
Server table appears.
Figure 18: Remote Syslog Server Table
Select the server from the table. The Remote Syslog Server form appears.
2.
64
Description
Default: 514
The UDP port number on which the remote server listens.
Synopsis: { USER, LOCAL0, LOCAL1, LOCAL2, LOCAL3, LOCAL4,
LOCAL5, LOCAL6, LOCAL7 }
Default: LOCAL7
Syslog Facility is one information field associated with a syslog
message. The syslog facility is the application or operating system
component that generates a log message. ROS map all syslog
logging information onto a single facility which is configurable by
user to facilitate remote syslog server.
Synopsis: { EMERGENCY, ALERT, CRITICAL, ERROR, WARNING,
NOTICE, INFORMATIONAL, DEBUGGING }
Default: DEBUGGING
The severity level is the severity of the message that has been
generated. Please note that the severity level user select is
accepted as the minimum severity level for the system. For
example, if user selects the severity level as 'Error' then the system
send any syslog message originated by Error, Critical, Alert and
Emergency.
RUGGEDCOM ROS
User Guide
Deleting a Remote Syslog Server