Deleting An Ip Interface - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Parameter
Subnet
Click Apply.
4.
Section 3.7.3

Deleting an IP Interface

To delete an IP interface configured on the device, do the following:
Navigate to Administration » Configure IP Interfaces . The IP Interfaces table appears.
1.
Figure 39: IP Interfaces Table
2. Select the IP interface from the table. The IP Interfaces form appears.
Deleting an IP Interface
Description
Specifies the IP address of this device. An IP address is a 32-bit
number that is notated by using four numbers from 0 through
255, separated by periods. Only a unicast IP address is allowed,
which ranges from 1.0.0.0 to 233.255.255.255.
Synopsis: ###.###.###.### where ### ranges from 0 to 255
Default: 255.255.255.0
Specifies the IP subnet mask of this device. An IP subnet mask
is a 32-bit number that is notated by using four numbers from
0 through 255, separated by periods. Typically, subnet mask
numbers use either 0 or 255 as values (e.g. 255.255.255.0) but
other numbers can appear.
IMPORTANT!
Each IP interface must have a unique network
address.
Chapter 3
Device Management
87