Adding A Remote Syslog Server - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Section 3.5.4.3

Adding a Remote Syslog Server

RUGGEDCOM ROS supports up to 5 remote syslog servers (or collectors). Similar to the local system log, a remote
system log server can be configured to log information at a specific severity level. Only messages of a severity
level equal to or greater than the specified severity level are written to the log.
To add a remote syslog server to the list of known servers, do the following:
1. Navigate to Administration » Configure Syslog » Configure Remote Syslog Server . The Remote Syslog
Server table appears.
1
Figure 16: Remote Syslog Server Table
1. InsertRecord
2. Click InsertRecord. The Remote Syslog Server form appears.
5
Figure 17: Remote Syslog Server Form
1. IP Address Box 2. UDP Port Box 3. Facility Box 4. Severity Box 5. Apply Button 6. Delete Button 7. Reload Button
3. Configure the following parameter(s) as required:
Parameter
IP Address
UDP Port
Adding a Remote Syslog Server
6
Description
Synopsis: ###.###.###.### where ### ranges from 0 to 255
Syslog server IP Address.
Synopsis: 1025 to 65535 or { 514 }
Chapter 3
Device Management
1
2
3
4
7
63