Managing Link Aggregation - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 5
Setup and Configuration
Parameter
quietPeriod
reAuthEnabled
reAuthPeriod
reAuthMax
suppTimeout
serverTimeout
maxReq
4. Click Apply.
Section 5.10

Managing Link Aggregation

Link aggregation, also referred to as port trunking or port bundling, provides the ability to aggregate or gather
several Ethernet ports into one logical link (port trunk) with higher bandwidth. This allows for highly randomized
load balancing between the aggregated links based on both the source and destination MAC addresses of the
forwarded frames.
Link Aggregation can be used for two purposes:
• To obtain increased, linearly incremental link bandwidth.
• To improve network reliability by creating link redundancy. If one of the aggregated links fails, the switch will
balance the traffic between the remaining links.
240
Description
Synopsis: 0 to 65535
Default: 60 s
The period of time not to attempt to acquire a Supplicant after the
authorization session failed.
Synopsis: { No, Yes }
Default: No
Enables or disables periodic re-authentication.
Synopsis: 60 to 86400
Default: 3600 s
The time between periodic re-authentication of the Supplicant.
Synopsis: 1 to 10
Default: 2
The number of re-authentication attempts that are permitted
before the port becomes unauthorized.
Synopsis: 1 to 300
Default: 30 s
The time to wait for the Supplicant's response to the
authentication server's EAP packet.
Synopsis: 1 to 300
Default: 30 s
The time to wait for the authentication server's response to the
Supplicant's EAP packet.
Synopsis: 1 to 10
Default: 2
The maximum number of times to retransmit the authentication
server's EAP Request packet to the Supplicant before the
authentication session times out.
RUGGEDCOM ROS
User Guide
Managing Link Aggregation