Scenario A: Connecting the SMA
on a New DMZ
The following procedures explain how to configure your
gateway appliance based on Scenario A:
•
Connecting the SMA to the Gateway on page 40
•
Allowing a WAN to SMA Connection on page 40
•
Allowing an SMA to LAN Connection on page 42
Connecting the SMA to the Gateway
To connect the SMA 200/400 using Scenario A:
1 Connect one end of an Ethernet cable to an unused
port on your SonicWall gateway appliance.
2 Connect the other end of the Ethernet cable to the X0
port on the front of your SonicWall Secure Mobile
Access 200/400. The X0 Port LED lights up indicating an
active connection.
3
Configure the SMA X0 IP address. Refer to Configuring
the X0 IP Address on page 34.
40
SonicWall Secure Mobile Access 200/400 Getting Started Guide
Allowing a WAN to SMA Connection
NOTE: Before continuing, you must add a new SMA
custom zone. Refer to Adding a New SMA Custom Zone
on page 38 for more information.
To allow a WAN to SMA connection:
1 Click the Wizards icon in the top right corner of the
gateway appliance management interface.
2 On the Welcome page, select the Public Server Guide,
and then click Next.