Loading Roll Material - Roland CM-500 User Manual

To cut off a piece of material with the separating knife, load the media within the range shown below.
Loading media outside this range may make it impossible to cut off the material with the separating knife.
13 mm (1/2") from the edge
of the leftmost grit roller

Loading Roll Material

* When performing lengthy cutting of 1.5 m (60") or more, please refer to the section " To
Perform Lengthy Cutting" that follows this one.
For information on how to install the sheet hanger, shaft, brake, and stoppers, please refer to the assembly manual for the PNS-500/
400/300 (the stand for the CM-500/400/300).
1
Mount the shaft at the location on the sheet hanger shown in the figure to match the outer diameter of
the rolled material.
When using a thick roll of
material
Shafts
2
Place the rolled material on the shaft.
3
Lower the sheet loading levers and raise the pinch rollers.
Pass the end of the material between the pinch rollers and
the grit rollers so that it extends from the front of the unit.
Separable range
When only a small amount
of material remains (mate-
rial diameter is 72 mm (2-7/
8") or less)...
Shafts
Sheet hanger
37 mm (1-7/16") from the edge
of the Rightmost grit roller
No good
Shafts
Sheet hanger
Stopper
Stopper
Shafts
15