Roland CM-500 User Manual page 18

4
Position so that the left-hand edge of the material lies over any one of the grit rollers.
Move the material from side to side and position so that the right-hand edge of the material lies over the rightmost grit roller.
Grit roller
5
Load the material so that it lies straight and is aligned with the guide-line marks, then move the left and right pinch rollers so
that at they are above the grit rollers.
Position the middle pinch roller over the grit roller that lies between the left- and right-hand pinch rollers.
If a pinch roller does not move easily, it may help to grasp the corresponding sheet loading lever at the back of the unit and
move it together with the pinch roller.
Rear View
Sheet loading lever
Material
6
Lift the sheet loading lever.
The pinch rollers are lowered and the material is
secured in place.
When using a material which is narrower than 762 mm
(30"), do not lower the pinch rollers.
8
Follow steps 1 through 7 to secure the media in place, then pull out the required length for cutting from the roller.
16
Sensor
Load the material so
that it lies over the
sensor on the platen.
7
Lift the sheet
loading levers
With the material set in place,
make sure the grit rollers are
positioned correctly.
Grit roller
Position the pinch rollers over
the material, near the edges.
Pinch roller (right)
Material
Guide-line marks
Position the stoppers so that they lightly touch the
edges of the roll, and secure in place by tightening the
screws.
Roll material
Screws