Loading Roll Material - Roland PNC-1860 User Manual

PNC-1210
The PNC-1210 has no middle pinch roller.
When loading material with a width other than one indicated above, move the right-hand movable pinch roller.
Turning on the Power
Switch on the power switch on the front of
the main unit.

Loading Roll Material

When using stand (The stand is sold separately.)
(PNC-1860: PNS-186, PNC-1410:PNS-141, PNC-1210: PNS-130)
(1) Install the two shafts on the sheet hanger.
(2) Place the roll material on top of the shafts.
Side view of loaded
roll material
Stopper
Shaft
Rear Front
6
The right-hand movable pinch roller can be moved within this range.
* One shaft should always be
installed here.
Install the shafts to match either
the remaining amount (roll width)
of the sheet, or the diameter of
the rolled sheet s core.
* Do not use with shafts installed
at both of these positions at the
same time.
If the diameter of the rolled sheet
core is 72 mm (2-7/8") or less
Install the shaft here if the amount
of sheet remaining is small.
Material
(approx. 457 mm)
24"
(approx. 610 mm)
30"
(approx. 762 mm)
Material with
Material with
a width
a width
of 18"
of 24" and 30"
* Do not set the pinch roller here.
30" (approx. 762 mm)
Power ON
PNC-1860
PNC-1860
Roland DG Corp.
PNC-1210
PNC-1210
Roland DG Corp.
Front
Rear
6"
(approx. 152 mm)
12" (approx. 305 mm)
18"
Material with a
Material with
width of 6"
a width
of 12"
PNC-1410
PNC-1410
Roland DG Corp.
Place the rolled
sheet here.
Shafts
Stopper
Sheet hangers