When Cutting Is Completed - Roland CM-500 User Manual

4-8 When Cutting is Completed

When not in use for extended
periods, unplug the power cord from
the electrical outlet.
Failure to do so may
result in danger of
shock, electrocution,
or fire due to
deterioration of the
electrical insulation.
NOTICE
Do not leave the tool mounting screws tightened. Tightening the screw makes it more difficult to install the
blade holder.
1
Lower the sheet loading levers and remove the
material.
3
Press the push-pin and remove the blade from the
blade holder.
If a blade was used, wipe the blade with a soft cloth to
remove any material that may cling to it.
Blade holder
Blade
26
remove the
Material
Press the push-pin
2
(1) Loosen the tool securing screw on the cutting
carriage.
(2) Remove the blade holder from the cutting carriage.
Tool securing screw
4
Turn off the power.
Cutting carriage
POWER/ERROR LED
goes out