Using Roll Material - Roland Stika SX-15 User Manual

Part 2 Performing Cutting

Using Roll Material

Material cannot be loaded on the SX-15/12/8 while still
attached to the roll.
Cut off from the roll a length of material equal to the
require length for cutting plus a margin of 30 mm.
The SX-15/12/8 can be loaded with material up to 1100
mm (43-1/4 in.) in length. However, the cutting area is
only up to 1,000 mm (39-5/16 in.).
- Cut off the material at a right angle.If the end of the roll material is not straight, then the next time cutting is per
formed material feed may not be performed correctly, and the material may move at an angle and come loose.
- Depending on the composition of the material, it may not be possible to cut some fluorescent or reflective material,
even if the material is of a cuttable thickness.
2-2
Up to
(43-1/4 in.)