Using The Display Menus - Roland CM-500 User Manual

6

Using the Display Menus

This section describes the basic steps for using the display menus. Use this information together with "7 Display Menus Flowchart" on
the following page to make menu settings.
Use the and keys to move the blinking cursor (" ") and choose a setting.
Then use the and keys to change the value (or the selection) and enable the setting by pressing the
Press the
the next menu
AREA AXIS
REPLOT SUBMENU
Use the and
blinking cursor (" ") and choose a setting
Press the
to the next setting screen
• To return to the menu selection screen from any of the menu value setting screens, press the
• To return to the previous screen without changing the numerical settings, pressing the
without pressing the
MENU key to change to
Select "AREA"
keys to move the
key to advance
key.
AREA LENGTH
MOVE <1.0m>
Then use the and keys to change the value and
enable the setting by pressing the
The value enclosed in angled brackets ("<>") is the current setting
Use the and keys to move the blinking cursor
(" ") and choose a setting
The selection enclosed in angled brackets ("<>") is the current setting
key.
ENTER key
key.
key
29