Checking Supplied Items; Part Names And Functions; Front View - Roland CM-500 User Manual

1

Checking Supplied Items

Check the following to make sure that you received all the items that were shipped along with the unit.
Power Cord: 1
Test-use
Application Tape
User's Manual
2

Part Names and Functions

2-1 Front View

Front Cover
Opening the cover during
operation pauses the
machine.
Movable Pinch Roller (Left)
Set this at the left-hand edge
of the material.
Power Switch
ON when switched to [
OFF when switched to [
Blade Holder
(XD-CH2)
Material for Test Cuts
CAMM-1 DRIVER
®
for windows 95
* The figure shows the CM-500 installed with the PNS-500 special stand.
Movable Pinch Roller (middle)
This is used when cutting materials with a width of 762 mm
(30") or more. At this time, it is set at the center of the left
and right pinch rollers or above the grit roller near the center.
Movable Pinch Roller (Right)
Set this at the right-hand edge
of the material.
Platen
].
] .
Cutter Protector
Blade (ZEC-U5025)
Tweezers
(for handling material)
Sheet sensor
Test use Water Based
Fiber Tipped Pen
Replacement blade
for separating knife
Tool Carriage
The tool carriage is where the
cutter (or pen) is mounted.
Separating knife
This cuts off a piece of material
from rolled material.
Operation Panel
Pen Force Control Slider
Guide line
These are used as guides for
making sure the loaded
material is straight. Align the
right-hand edge of the material
with these scale lines.
Grit Roller
The pinch rollers and grit
rollers grip the material and
move it forward and backward.
7