Table of Contents
Advertisement
4
Basic Operation
4-1 Installing a Blade
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
NOTICE
Be sure to support the tool mounting screw from below when installing the blade holder.
Cutting quality may become poor if installed without supporting the screw in this way.
1
Insert a blade into the blade holder until it snaps into
place with an audible click.
Push-pin
Blade holder
Blade
How to Set the Blade Offset
Set the blade offset for the installed blade. For more information about offset, see "9 About Blades and Material."
(1) Close the front cover and press the
Blade compensation
Setting range: 0—1.000 mm
(2) Use the
and
keys to enter the offset value, then press the
Depending on the material in use, it may be necessary to adjust the tip of the blade. For more information, see "4-5 Cutting Test."
12
key until the message shown below appears.
1 CUT
0.250mm
(in increments of 0.025 mm)
2
(1) Loosen the tool securing screw on the cutting
carriage.
(2) Support the tool-securing screw from below and
install the blade holder. Insert the blade holder
until the collar is flush with the carriage.
(3) Tighten the tool securing screw until the blade
holder is secured in place.
Loosen
Tool securing screw
50cm/s
30gf
key to accept the value.
Tool carriage
Tighten
Hide quick links:
Advertisement
Table of Contents
