How To Replace The Separating Knife - Roland CM-500 User Manual

5-2 How to Replace the Separating Knife

Make sure the power to the unit is
off before attempting to replace the
separating knife.
Doing so may result in injury.
If the separating knife, replace it with the replacement blade included with the CM-500/400/300.
Follow the steps below to replace the blade.
1
Switch off the power to the CM-500/400/300.
3
Replace with a new knife.
Positioning groove
The knife is secured in place
by the magnet.
28
2
Remove the separating knife.
(1) Loosen the screw until it slips out.
(2) Grasp the screw portion, and slowly pull it out in the
direction of the arrow.
* Do not pull back while doing this.
* If the blade remains in the carriage, use the included tweezers
to remove it.
4
Install the separating knife.
(1) Grasp the screw portion and slowly insert it into
the groove.
* Take care to ensure that the knife does not slip
(2) Tighten the screw.
(2)
(1)
(1)
(2)