Disabling 802.1X Authentication On The Port - Cisco 3032 Software Configuration Manual

Configuring 802.1x Authentication
Switch(config)# authentication fallback profile1
Switch(config)# authentication host-mode multi-auth
Switch(config)# authentication open
Switch(config)# authentication order dot1x webauth
Switch(config)# authentication periodic
Switch(config)# authentication port-control auto

Disabling 802.1x Authentication on the Port

You can disable 802.1x authentication on the port by using the no dot1x pae interface configuration
command.
Beginning in privileged EXEC mode, follow these steps to disable 802.1x authentication on the port.
This procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 no dot1x pae
Step 4 end
Step 5
show authentication interface-id
or
show dot1x interface interface-id
Step 6 copy running-config startup-config
To configure the port as an 802.1x port access entity (PAE) authenticator, which enables IEEE 802.1x
on the port but does not allow clients connected to the port to be authorized, use the dot1x pae
authenticator interface configuration command.
This example shows how to disable 802.1x authentication on the port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# no dot1x pae authenticator
Resetting the 802.1x Authentication Configuration to the Default Values
Beginning in privileged EXEC mode, follow these steps to reset the 802.1x authentication configuration
to the default values. This procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 dot1x default
Step 4 end
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
9-64
Chapter 9
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Disable 802.1x authentication on the port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the port to be configured.
Reset the 802.1x parameters to the default values.
Return to privileged EXEC mode.
Configuring IEEE 802.1x Port-Based Authentication
OL-12247-04