Using Vlan Maps With Router Acls - Cisco 3032 Software Configuration Manual

Using VLAN Maps with Router ACLs

This example shows how to deny access to a server on another VLAN by creating the VLAN map
SERVER 1 that denies access to hosts in subnet 10.1.2.0.8, host 10.1.1.4, and host 10.1.1.8 and permits
other IP traffic. The final step is to apply the map SERVER1 to VLAN 10.
Define the IP ACL that will match the correct packets.
Step 1
Switch(config)# ip access-list extended SERVER1_ACL
Switch(config-ext-nacl))# permit ip 10.1.2.0 0.0.0.255 host 10.1.1.100
Switch(config-ext-nacl))# permit ip host 10.1.1.4 host 10.1.1.100
Switch(config-ext-nacl))# permit ip host 10.1.1.8 host 10.1.1.100
Switch(config-ext-nacl))# exit
Define a VLAN map using this ACL that will drop IP packets that match SERVER1_ACL and forward
Step 2
IP packets that do not match the ACL.
Switch(config)# vlan access-map SERVER1_MAP
Switch(config-access-map)# match ip address SERVER1_ACL
Switch(config-access-map)# action drop
Switch(config)# vlan access-map SERVER1_MAP 20
Switch(config-access-map)# action forward
Switch(config-access-map)# exit
Step 3 Apply the VLAN map to VLAN 10.
Switch(config)# vlan filter SERVER1_MAP vlan-list 10.
Using VLAN Maps with Router ACLs
To access control both bridged and routed traffic, you can use VLAN maps only or a combination of
router ACLs and VLAN maps. You can define router ACLs on both input and output routed VLAN
interfaces, and you can define a VLAN map to access control the bridged traffic.
If a packet flow matches a VLAN-map deny clause in the ACL, regardless of the router ACL
configuration, the packet flow is denied.
When you use router ACLs with VLAN maps, packets that require logging on the router ACLs are not
Note
logged if they are denied by a VLAN map.
If the VLAN map has a match clause for the type of packet (IP or MAC) and the packet does not match
the type, the default is to drop the packet. If there is no match clause in the VLAN map, and no action
specified, the packet is forwarded if it does not match any VLAN map entry.
These sections contain information about using VLAN maps with router ACLs:
•
•
VLAN Maps and Router ACL Configuration Guidelines
These guidelines are for configurations where you need to have an router ACL and a VLAN map on the
same VLAN. These guidelines do not apply to configurations where you are mapping router ACLs and
VLAN maps on different VLANs.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
34-36
VLAN Maps and Router ACL Configuration Guidelines, page 34-36
Examples of Router ACLs and VLAN Maps Applied to VLANs, page 34-37
Chapter 34 Configuring Network Security with ACLs
OL-12247-04