Cisco 3032 Software Configuration Manual page 356

Configuring Ethernet Interfaces
the interface is connected. When you put an interface that is in Layer 3 mode into Layer 2 mode, the
previous configuration information related to the affected interface might be lost, and the interface is
returned to its default configuration.
Table 11-2
Feature
Operating mode
Allowed VLAN range
Default VLAN (for access ports)
Native VLAN (for IEEE 802.1Q
trunks)
VLAN trunking
Port enable state
Port description
Speed
Duplex mode
Flow control
EtherChannel (PAgP)
Port blocking (unknown multicast
and unknown unicast traffic)
Broadcast, multicast, and unicast
storm control
Protected port
Port security
Port Fast
Auto-MDIX
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
11-18
Default Layer 2 Ethernet Interface Configuration
Default Setting
Layer 2 or switching mode (switchport command).
VLANs 1– 4094.
VLAN 1 (Layer 2 interfaces only).
VLAN 1 (Layer 2 interfaces only).
Switchport mode dynamic auto (supports DTP) (Layer 2 interfaces
only).
All ports are enabled.
None defined.
1000 Mb/s for the internal ports (nonconfigurable)
Autonegotiate for the external 10/100/1000-Mb/s and SFP module
ports. (Not supported on the 10-Gigabit interfaces.)
Full duplex for the internal ports (nonconfigurable)
Autonegotiate for the external 10/100/1000-Mb/s and SFP module
ports. (Not supported on the 10-Gigabit interfaces.)
Flow control is set to receive: off. It is always off for sent packets.
Disabled on all Ethernet ports. See
EtherChannels and Link-State Tracking."
Disabled (not blocked) (Layer 2 interfaces only). See the
"Configuring Port Blocking" section on page
Disabled. See the
on page
Disabled (Layer 2 interfaces only). See the
Ports" section on page
Disabled (Layer 2 interfaces only). See the
Configuration" section on page
Disabled. See the
Configuration" section on page
Enabled.
Chapter 11
"Default Storm Control Configuration" section
26-3.
26-6.
26-11.
"Default Optional Spanning-Tree
20-12.
Configuring Interface Characteristics
Chapter 37, "Configuring
26-7.
"Configuring Protected
"Default Port Security
OL-12247-04