Cisco 3032 Software Configuration Manual page 864

Configuring Standard QoS
Beginning in privileged EXEC mode, follow these steps to create a class map and to define the match
criterion to classify traffic:
Command
Step 1 configure terminal
Step 2
access-list access-list-number {deny |
permit} source [source-wildcard]
or
access-list access-list-number {deny |
permit} protocol source
[source-wildcard] destination
[destination-wildcard]
or
ipv6 access-list access-list-name
{deny | permit} protocol
{source-ipv6-prefix/prefix-length | any |
host source-ipv6-address}
[operator [port-number]]
{destination-ipv6-prefix/ prefix-length |
any | host destination-ipv6-address}
[operator [port-number]]
[dscp value] [fragments] [log] [log-input]
[routing] [sequence value] [time-range
name]
or
mac access-list extended name
{permit | deny} {host src-MAC-addr mask
| any | host dst-MAC-addr | dst-MAC-addr
mask} [type mask]
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
36-50
Purpose
Enter global configuration mode.
Create an IP standard or extended ACL or an IPv6 ACL for IP traffic,
or a Layer 2 MAC ACL for non-IP traffic, repeating the command as
many times as necessary.
For more information, see the
section on page 36-44.
When creating an access list, remember that, by default, the
Note
end of the access list contains an implicit deny statement for
everything if it did not find a match before reaching the end.
Chapter 36
"Classifying Traffic by Using ACLs"
Configuring QoS
OL-12247-04