802.1X Authentication Configuration Guidelines - Cisco 3032 Software Configuration Manual

Configuring 802.1x Authentication

802.1x Authentication Configuration Guidelines

This section has configuration guidelines for these features:
•
•
•
•
802.1x Authentication
These are the 802.1x authentication configuration guidelines:
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
9-34
802.1x Authentication, page 9-34
VLAN Assignment, Guest VLAN, Restricted VLAN, and Inaccessible Authentication Bypass,
page 9-35
MAC Authentication Bypass, page 9-36
Maximum Number of Allowed Devices Per Port, page 9-36
When 802.1x authentication is enabled, ports are authenticated before any other Layer 2 or Layer 3
features are enabled.
If you try to change the mode of an 802.1x-enabled port (for example, from access to trunk), an error
message appears, and the port mode is not changed.
If the VLAN to which an 802.1x-enabled port is assigned changes, this change is transparent and
does not affect the switch. For example, this change occurs if a port is assigned to a RADIUS
server-assigned VLAN and is then assigned to a different VLAN after re-authentication.
If the VLAN to which an 802.1x port is assigned to shut down, disabled, or removed, the port
becomes unauthorized. For example, the port is unauthorized after the access VLAN to which a port
is assigned shuts down or is removed.
The 802.1x protocol is supported on Layer 2 static-access ports, voice VLAN ports, and Layer 3
routed ports, but it is not supported on these port types:
Trunk port—If you try to enable 802.1x authentication on a trunk port, an error message
–
appears, and 802.1x authentication is not enabled. If you try to change the mode of an
802.1x-enabled port to trunk, an error message appears, and the port mode is not changed.
Dynamic ports—A port in dynamic mode can negotiate with its neighbor to become a trunk
–
port. If you try to enable 802.1x authentication on a dynamic port, an error message appears,
and 802.1x authentication is not enabled. If you try to change the mode of an 802.1x-enabled
port to dynamic, an error message appears, and the port mode is not changed.
Dynamic-access ports—If you try to enable 802.1x authentication on a dynamic-access (VLAN
–
Query Protocol [VQP]) port, an error message appears, and 802.1x authentication is not
enabled. If you try to change an 802.1x-enabled port to dynamic VLAN assignment, an error
message appears, and the VLAN configuration is not changed.
– EtherChannel port—Do not configure a port that is an active or a not-yet-active member of an
EtherChannel as an 802.1x port. If you try to enable 802.1x authentication on an EtherChannel
port, an error message appears, and 802.1x authentication is not enabled.
– Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports—You can
enable 802.1x authentication on a port that is a SPAN or RSPAN destination port. However,
802.1x authentication is disabled until the port is removed as a SPAN or RSPAN destination
port. You can enable 802.1x authentication on a SPAN or RSPAN source port.
Chapter 9 Configuring IEEE 802.1x Port-Based Authentication
OL-12247-04