Configuring Ip Unicast Routing - Cisco 3032 Software Configuration Manual

Configuring IP Unicast Routing

This chapter describes how to configure IP Version 4 (IPv4) unicast routing on the switch. Unless
otherwise noted, the term switch refers to a standalone switch and to a switch stack. A switch stack
operates and appears as a single router to the rest of the routers in the network.
Basic routing functions, including static routing and the Routing Information Protocol (RIP), are
available with both the IP base feature set and the IP services feature set. To use advanced routing
features and other routing protocols, you must have the IP services feature set enabled on the standalone
switch or on the stack master.
Note If the switch or switch stack is running the IP services feature set, you can also enable IP Version 6
(IPv6) unicast routing and configure interfaces to forward IPv6 traffic in addition to IPv4 traffic. For
information about configuring IPv6 on the switch, see
For more detailed IP unicast configuration information, see the Cisco IOS IP Configuration Guide,
Release 12.2 from the Cisco.com page under Documentation > Cisco IOS Software > 12.2 Mainline
> Configuration Guides. For complete syntax and usage information for the commands used in this
chapter, see these command references from the Cisco.com page under Documentation > Cisco IOS
Software > 12.2 Mainline > Command References:
Cisco IOS IP Command Reference, Volume 1 of 3: Addressing and Services, Release 12.2
•
• Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release 12.2
Cisco IOS IP Command Reference, Volume 3 of 3: Multicast, Release 12.2
•
This chapter consists of these sections:
Understanding IP Routing, page 38-2
•
Steps for Configuring Routing, page 38-5
•
Configuring IP Addressing, page 38-5
•
Enabling IP Unicast Routing, page 38-19
•
Configuring RIP, page 38-20
•
Configuring OSPF, page 38-26
•
Configuring EIGRP, page 38-37
•
Configuring BGP, page 38-46Configuring ISO CLNS Routing, page 38-67
•
• Configuring Multi-VRF CE, page 38-77
• Configuring Protocol-Independent Features, page 38-92
OL-12247-04
C H A P T E R
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
38
Chapter 39, "Configuring IPv6 Unicast Routing."
38-1