Configuring Eigrp Interfaces - Cisco 3032 Software Configuration Manual

Configuring EIGRP

Configuring EIGRP Interfaces

Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3 ip bandwidth-percent eigrp percent
Step 4 ip summary-address eigrp
autonomous-system-number address mask
Step 5
ip hello-interval eigrp autonomous-system-number
seconds
Step 6
ip hold-time eigrp autonomous-system-number
seconds
Step 7 no ip split-horizon eigrp autonomous-system-number (Optional) Disable split horizon to allow route information
Step 8 end
Step 9 show ip eigrp interface
Step 10
copy running-config startup-config
Use the no forms of these commands to disable the feature or to return the setting to the default value.
Configuring EIGRP Route Authentication
EIGRP route authentication provides MD5 authentication of routing updates from the EIGRP routing
protocol to prevent the introduction of unauthorized or false routing messages from unapproved sources.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
38-42
Chapter 38
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
(Optional) Change the hello-time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
(Optional) Change the hold-time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
Do not adjust the hold time without consulting
Caution
Cisco technical support.
to be advertised by a router from any interface that
originated that information.
Return to privileged EXEC mode.
Display which interfaces EIGRP is active on and
information about EIGRP relating to those interfaces.
(Optional) Save your entries in the configuration file.
Configuring IP Unicast Routing
OL-12247-04