Connecting To The Ieee 1284 Interface - Ricoh 5100WD General Settings Manual

1. Connecting the Machine
• For Windows Me:
Make sure to install "USB Printing Support". When used with Windows Me, only a speed
equal to that of USB1.1 is possible.
1
• For Mac OS:
When used with Mac OS X 10.3.3 or higher, a transfer speed of USB2.0 is supported.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.

Connecting to the IEEE 1284 Interface

This section describes how to connect the IEEE 1284 interface cable to the IEEE 1284 interface board.
• Properly shielded and grounded cables and connectors must be used for connections to a host
computer (and/or peripheral) in order to meet emission limits.
1. Make sure the main power switch of the machine is off.
2. Turn off the main power switch of the host computer.
3. Connect the IEEE 1284 interface cable to the IEEE 1284 port.
4. Connect the other end of the cable into the interface connector on the host computer.
Check the shape of the connector to the computer. Connect the cable firmly.
5. Turn on the main power switch of the machine.
6. Turn on the host computer.
When using Windows 2000/XP/Vista and Windows Server 2003, a printer driver installation screen
might appear when the computer is turned on. If this happens, click [Cancel] on the screen.
• For details about how to turn on the main power switch, see "Turning On the Power", About This
Machine.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
18
BLL010S