Connecting The Machine; Connecting To The Interfaces - Ricoh 5100WD General Settings Manual

1. Connecting the Machine

This chapter describes how to connect the machine to the network and specify the network settings.

Connecting to the Interfaces

This section describes how to identify the machine's interface and connect the machine according to the
network environment.
• A network interface cable with a ferrite core must be used for RF interference suppression.
1. 10BASE-T/100BASE-TX port
Port for connecting the 100BASE-TX or 10BASE-T cable
2. USB2.0 port
Port for connecting the USB2.0 interface cable
3. IEEE 1284 ports (optional)
Port for connecting the IEEE 1284 interface cable
4. Wireless LAN port (optional)
Port for using the wireless LAN
5. Gigabit Ethernet port (optional)
Port for using the 1000BASE-T, 100BASE-TX, or 10BASE-T cable
• Some options cannot be attached to the machine if other options are already attached. For details
about what combinations of options are possible, contact your sales or service representative.
• If the optional Gigabit Ethernet board is installed, the 10BASE-T/100BASE-TX port on the board
cannot be used.
1
BLL001S
13