Ricoh 5100WD General Settings Manual page 60

2. System Settings
These settings do not apply for hemmed paper.
Depending on paper type, operating conditions (low temperature and humidity), and paper feeding
settings (multiple copies on paper of 542 mm, 22" width or less), toner fusing conditions vary. To
improve toner fusing, change the thickness level to 3
When using thin, soft, or limp paper, toner fusing may appear wrinkled or the image may be blurred.
If this happens, change the thickness level to 3
2
When level 1 or 2 are selected for translucent paper, and you change the paper type from plain or
film to translucent, it may take longer for the machine to get ready for copying (up to two minutes).
When level 1 or 2 are selected for translucent paper, and you make copies on paper of size A1 or
above continuously, the interval between each copying may take longer. Even if you make copy on
one sheet only, it may takes 1 minute until the next copy job starts.
Paper Thickness: Paper Bypass
Specify the thickness of paper placed in the paper bypass.
If the copy image blurs or the translucent paper becomes loose, changing the paper thickness level
may improve the situation.
The default setting for "Plain Paper" is 3.
The default setting for "Recycled Paper" is 3.
The default setting for "Translucent Paper" is 2.
The default setting for "Film" is 3.
For information on the available settings, see the table titled "Paper Thickness: Paper Tray."
Paper Volume
Specify the initial remaining volume of roll paper to be displayed for each paper tray.
The system monitors the amount of paper used, and automatically determines the remaining volume,
based on the specified initial remaining volume.
We recommend that you specify an appropriate remaining volume each time a paper tray is loaded.
Select "New (Full)" when a paper tray is loaded with a new 150 m roll of paper.
The default setting is New (Full).
58
2 1.
4 5.