Polaris SPORTSMAN 600 Service Manual page 92

28. Remove the oil pressure relief. The oil pressure
relief consists of a bolt, washer, spring, and valve
(dowel). Inspect the the valve (dowel) for signs of
possible obstructions. Use compressed air to
blow out any debris.
29. Reinstall the valve (dowel chamfered end first).
Install the spring, washer, and bolt. Torque the
bolt to 22 ± 2 ft. lbs. (30 ± 3 Nm).
NOTE: Be sure to place the tapered end of the valve
(dowel) in first. If the valve is installed incorrectly, oil
pressure and oil priming problems will occur.
3.42
DISASSEMBLY OF WATER/OIL PUMP SHAFT
during
clothing and eyewear are required.
30. Carefully press the gear off the assembly while
31. Remove the snap ring from the assembly. Place
Press out
.
22 ± 2 ft.lbs
shaft and
(30 ± 3 Nm)
bearing
assembly
Chamfered
end first
32. Place the shaft in a press to remove the bearing.
WARNING
Wear appropriate safety gear
this procedure.
supporting the housing assembly.
the housing in a support and press out the
bearing/shaft assembly.
Bearing
ENGINE
Protective gloves,
Press off gear
Bearing
Retaining Ring