Polaris SPORTSMAN 600 Service Manual page 191

10. Remove the spacer washer (D), armature plate
(E), and rubber O--ring from the output cover.
D
E
11. Inspect the armature plate (E) for a consistent
wear pattern. Uneven wear of the armature plate
(E) indicates a warped plate, which may cause
intermittent operation. NOTE:
GEARCASE DIAGNOSIS" later in this chapter for
more details.
E
12. Remove the output hub (G) from the cover.
Remove the thrust bearing (F) from the output
hub (G). Inspect the thrust bearing (F) and the
dowel (H).
O--ring
13. Inspect the magnetic coil (I) in the output housing.
NOTE:
later in this chapter for more details on the coil.
14. Inspect the back lash pad (J) for excessive wear.
See "FRONT
NOTE: The backlash for the centralized hilliard is set
at the factory. No readjustment is required.
15. Remove the other output hub (K) from the main
gearcase. Inspect the inner bearing (L) for wear.
If there is excessive wear, replace bearing as
needed.
FINAL DRIVE
H
G
F
See "FRONT GEARCASE DIAGNOSIS"
I
J
7.19