Mark Components Before Disassembly
Mark Components Before Disassembly
3. Place the driven assembly into the clutch holder.
Push helix inward. Remove snap ring (A) and
washer (B). NOTE: The spring is a compression
spring only and has no torsional wind.
A
B
NOTE: Rotating the moveable sheave so that the
rollers are not in contact with either helix ramp
surfaces will lessen the effort needed to push the helix
inward.
4. Remove helix (C), spring (D), and spring seat
washer (E) and inspect for wear or damage.
Replace if worn.
NOTE: Note the keyed spline on the shaft and
helix for reassembly. The keyed shaft ensure
proper alignment of the helix to the shaft.
CLUTCH
C
D
6.25