Headlamp Switch - Polaris SPORTSMAN 600 Service Manual

ELECTRICAL
Bulb
1. From the rear of the taillight remove two screws
holding lens cover in place and remove lens
cover.
2. Remove lamp and replace it with recommended
lamp. Apply Dielectric Grease (PN 2871329).
3. Reinstall the lens cover removed in step 1.
4. Test the taillight/brakelight to see it is working.

HEADLAMP SWITCH

Remove the headlight pod cover.
headlamp plug wires (Brown and Yellow) at back of
connector. Turn headlight on.
Brown
Headlamp Plug Wires
BRAKE LIGHT SWITCH
1. Remove the front cover.
Brake Lamp Switch
10.32
Lens Cover
Probe the
Yellow
Brake Switch Locations: Un-
der front cover close to CDI
box.
2. Disconnect wire harness from switch.
3. Connect an ohmmeter across switch contacts.
Reading should be infinite (∞).
4. Apply brake at handlebar lever and check for
continuity between switch contacts.
switch if there is no continuity or greater than .5
ohms resistance when the brake is applied with
slight pressure.
Replace