FINAL DRIVE
7. Install the armature plate (D) and spacer washer
(E) into the output cover. NOTE:
backlash plate is in place.
E
D
8. Install the retaining ring (F) into the output cover.
Be sure the retaining ring is properly seated into
the cover.
F
9. Install the ring gear onto the output hub on the
output cover.
10. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.
7.22
Be sure
Backlash Plate
G
11. Install the output cover assembly onto the main
gearcase.
NOTE: Be sure armature plate tabs are placed into
the slots on roll cage. (See Reference Photo)
Photo for reference only!
Armature Plate Tabs Fit Into Rollcage Slots
NOTE: This photo is for reference only, the armature
plate is actually installed in the output cover.
12. Install output cover with new o-ring and torque
bolts to 14 ft. lbs. (19 Nm).