Yamaha RX10H Service Manual page 99

STEERING
6. Adjust:
S Skis
Adjustment steps:
S Temporarily install the handlebar.
S Hold the handlebar straight and check that
the skis and relay arms are at right angles to
the handlebar.
S Loosen the locknuts (steering shaft) 1 .
S Hold the handlebar straight.
S Adjust the steering shaft 2 by turning so that
the right and left relay arms point right under.
S Adjust each angle of right and left skis by
turning the tie rod respectively.
Turning the steering
shaft in direction
Turning the steering
shaft in direction
S Tighten the locknuts (Steering shaft) 1 .
Loknut (steering shaft):
25 Nm (2.5 mSkg, 18 ftSlb)
LOCTITE
7. Install:
S Handlebar
CAUTION:
S Be sure the projection on the handlebar is
not installed into the area a shown.
S Be sure the side of the holder with the small
gap b faces forward.
S First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
S Center the match mark c on the handlebar
1 between the lower handlebar holders 2 .
Bolt (handlebar holder):
15 Nm (1.5 mSkg, 11 ftSlb)
3-10
CHAS
Turning the
handlebar in
a
direction c
Turning the
handlebar in
b
direction
d