Yamaha RX10H Service Manual page 667

SPEC
CABLE ROUTING
Place the damper locating
between the fuel tank and
sheet.
To the tail/brake light.
Sub-wire harness
Brake hose
Fuel sender lead cover
Auxiliary DC jack coupler
Headlight lead coupler
To the meter assembly.
Clamp the headlight lead.
Rout the headlight stay.
Align the hole of dia. 3 mm
(0.12 in) of the steering gate
with the white tape position of
the harness and secure them.
Install the 12 pin connector to
the top surface.
Fit it to the extension wire har-
ness.
To the headlight.
Drive guard bracket
Attach the battery negative lead
to the cell motor fixing bolt.
Front cover
Screw
Rectifier/regulator
Flange bolt
Put the boots of the meter cou-
pler in the boss root on the side
of the meter.
Fuel injection system relay
Headlight relay
Load relay
Radiator fan motor relay
Installation position of each
relay can be selected freely.
Clamp the wire harness and
speed sensor lead.
(Be sure to fold so that the har-
nesses cannot be discon-
nected.)
Sub-wire lead (ignition coil lead)
Wire harness
Clamp the ignition coil lead so
that it can be set within this
range. (It should not be caught
between the wire harness and
steering gate.)
Clamp the leads of the radiator
fan motor and back buzzer and
then fold the clamp by 90
degrees.
138