Yamaha RX10H Service Manual page 88

REAR SUSPENSION
S Turn the adjusting bolt 2 to the desired posi-
tion.
CAUTION:
Be sure the adjusting bolt ends are set at the
same position on each side.
S While holding the adjusting bolt securely,
tighten the nut 1 .
Nut (shock absorber):
49 Nm (4.9 mSkg, 35 ftSlb)
CAUTION:
Never allow the adjusting bolt to move while
tightening the nut.
S This model has a "Easy adjust" system for
the Full rate adjuster. The bolt has teeth on it.
So when the bolt is turned, it rides up and
down the bracket.
NOTE:
S The nut has to be loosen first, while the bolt is
held in place with a wrench.
S Then the bolt can be turned to adjust the shock
position up or down.
S If the bolt is turned with the nut tight, it is pos-
sible to strip the teeth off the bolt.
2-72
INSP
ADJ