Yamaha RX10H Service Manual page 406

1 Headlight wire harness
2 Tighten the frame ground and
voltage regulator upper bolt to-
gether.
3 Engine oil tank hose
4 Point the clamp tightening
direction to the downward.
5 Drain hose
6
Less than 30 mm (1.2 in).
7
Pass the coolant reservoir tank
breather hose through be-
tween engine and heat ex-
changer.
8
Clamp the hose at the white
paint position. Point the clamp
position to the front outside.
9
To the tail / brake light.
10
Clamp the coolant hose. Point
the locked section of the clamp
to the outside.
11 Clamp the wire harness. Tight-
en the frame cross member
and frame together.
12 Fuse box
13
Bracket
Connect the gear position
14
switch lead. (For model with the
reverse) Fold back the gear
position switch lead, and clamp
it. (For model without reverse)
15 Wire harness
16 Coolant reservoir tank
17 Coolant reservoir tank breather
hose
18 Brake hose
19 Parking brake cable
20 Point the clamp position to the
front outside.
21 Clamp the battery positive lead
and negative lead.
22 Point the clamp position to the
downward.
Point the clamp position to the
23
inside.
Clamp the leads before the fix-
24
ture.
CABLE ROUTING
71
SPEC