Yamaha RX10H Service Manual page 665

SPEC
CABLE ROUTING
CABLE ROUTING
Clamp the A.C. magneto lead
and wire harness ground lead.
Clamp the wire harness and
A.C. magnet lead to the raised
portion of the battery bracket.
Battery positive lead
Main fuse
Main harness
Battery negative lead
Flange bolt
Clamp the wire harness to the
steering gate clamp.
Make sure to place the wire har-
ness junction at the rear end
behind the clamp.
Fit it to the sub-lead wire 3.
Clamp
Route the sub-lead wire 3 and
cell motor positive lead over the
battery bracket and clamp them
to the battery bracket.
Oil level switch lead coupler
Oil level switch
Point both clips at two points
upward.
Clip
Pipe 2
Coolant temperature sensor
lead coupler
To the brake caliper.
Main switch lead coupler
To the heat exchanger
Clip
Route the tail/brake light leads
over the raised portion.
Fuel pipe
Clamp
136