Yamaha RX10H Service Manual page 669

SPEC
CABLE ROUTING
Right handlebar switch
Tube lead
Handlebar holder (Route the
wire harness, parking brake
cable, throttle cable.)
Parking brake cable
Left handlebar switch
Pass all the wire harness, brake
hose, brake cable and throttle
cable through it.
Arrange the line of cables and
hoses as shown in the illustra-
tion and they should not lap
over each other.
Pass all the wire harness, brake
hose, brake cable and throttle
cable through it.
Clamp the cover and bearing
holder.
Auxiliary DC jack
Clamp the steering gate and
fuel tank breather hose.
After fitting, bundle the cou-
plers of the brake light switch,
lever holder 1, lever holder 3,
thumb warmer, head light beam
switch, lever holder 2, grip
×
warmer 2, grip warmer switch
handle and thumb warmer
switch handle with the cover,
and then close at two points of
bosses.
Fit the wire harness from the
handle with the wire harness of
the white tape.
140