Yamaha RX10H Service Manual page 355

STEERING
9. Install:
S Handlebar
CAUTION:
S Be sure the projection on the handlebar is
not installed into the area a shown.
S Be sure the side of the holder with the small
gap b faces forward.
b = 0 mm (0 in)
S First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
S Center the match mark c on the handlebar
1 between the lower handlebar holders 2 .
Bolt (handlebar holder):
15 Nm (1.5 mSkg, 11 ftSlb)
20
CHAS