Drum Heater-C1 - Canon imageRUNNER 2525 Series Service Manual

Drum Heater-C1

Checking before Installation
■ Check Items When Turning OFF the
Main Power
Check that the main power switch is OFF.
1. Turn OFF the main power switch of the host machine.
2. Be sure that Control Panel Display and Main Power
Lamp are both turned OFF, and then disconnect the
power plug from the outlet.
■ Points to Note on Installation
The Heater Kit must be installed before installing the Drum
Heater.
Checking the Contents
Make sure that none of the following parts are missing.
[1] Drum Heater Unit x1
[3] Edge Saddle x 1
Installation Procedure
CAUTION:
Check that the main power switch is OFF and the
power plug is disconnected from the outlet.
[2] Wire Saddle x 2
[4] Relay Cable x 1
368
1. Open the front cover.
2. Push the button to open the right cover.
CAUTION:
To avoid any damage on the drum unit, keep the right
cover opening by 5 cm or more during installation.
3. Turn the lock lever as shown in the figure and
remove the waste toner container.
4. Remove 1 screw from the developing pressure lever.
(The screw does not exist in some machine versions
by destination.)
• 1 Screw
9. Installation