Using The Mode; Setting Of Bit Switch - Canon imageRUNNER 2525 Series Service Manual

Using the Mode

<Operation at the time of Bit SW>
NOTE:
Push the (*) key when inputting the minus(-).
Therefore, (+) and (-) is changed.

Setting of Bit Switch

■ Outline
● Bit Switch Composition
The items registered and set by each of these switches comprise 8-bit switches.
The figure below shows which numbers are assigned to which bits. Each bit has a value of either 0 or 1.
CAUTION:
Do not change service data identified as "not used"; they are set as initial settings.
1) Selecting Service Mode
# S S S W
2) Press [OK] on the
touch panel.
# S S S W
0 0 1 000000000
3) Selecting a Menu Item
Press [OK].
# S S S W
0 3 3
000000000
4) Selecting a Bit Switch
Select the bit using the
[left arrow]/[right arrow] on
the touch panel.
# S S S W
0 3 3
000000000
5) Registering/Setting Data
Enter data using the keypad,
and press the [OK].
# S S S W
0 3 3
000000001
6) Press the [Stop]/[Additional
functions]/[Reset] key to end
the service mode.
#SSSW
001
<Operation at the time of Parameter>
1) Selecting Service Mode
#SSSW
2) Selecting a Menu Item
Select the Menu item using the
[left arrow]/[right arrow] on the
touch panel.
# N U M E R I C
3) Press [OK].
# N U M E R I C
0 0 1
4) Selecting a Prarameter
Select the Prarameter using the
[left arrow]/[right arrow].
# N U M E R I C
0 0 2
5) Registering/Setting Data
Enter data using the keypad,
and then press [OK].
# N U M E R I C
0 0 2
6) Press the [Stop]/[Additional
functions]/[Reset] key to end
the service mode.
0 0 0 0 0 0 0 0
223
8. Service Mode
0
0
1 0