Cst Heater Kit-J1 - Canon imageRUNNER 2525 Series Service Manual

Cst Heater Kit-J1

Checking Before Installation
■ Check Items when Turning OFF the
Main Power
Check that the main power switch is OFF.
1. Turn OFF the main power switch of the host machine.
2. Be sure that Control Panel Display and Main Power
Lamp are both turned OFF, and then disconnect the
power plug from the outlet.
Checking the Contents
Make sure that none of the following parts are missing.
[1] Heater PCB x1
[3] Heater AC Harness x1
[5] High Temperature
Caution Label x1 *1
[7] Screw
(RS Tightening; M3x8) x1
*1: These items are used only when install the cassette
heater to the 250 sheets cassette. Also, save these even
when the cassette heater is not installed.
Installation Procedure
CAUTION:
Check that the main power switch is OFF and the
power plug is disconnected from the outlet.
[2] Heater SW Harness x1
[4] Heater DC Harness x1
[6] Cassette Heater Sheet
x1 *1
1. Remove the rear cover (right).
• 3 Screws
• 2 Claws
3x
Claws
2. Cut off the face cover of the rear cover (right) by a
side cutters as shown in the figure.
CAUTION:
Be sure to remove the face cover properly so that no
burr is formed.
341
9. Installation