Qppb Configuration Example In An Mpls L3Vpn - HP FlexNetwork MSR Series Configuration Manuals

Behavior: qppb
Committed Access Rate:
CIR 512 (kbps), CBS 32000 (Bytes), EBS 512 (Bytes)
Green action
Yellow action : pass
Red action
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets

QPPB configuration example in an MPLS L3VPN

Network requirements
As shown in
Configure QPPB so that Router C can perform the following operations:
•
Receive routes.
•
Set the QPPB local QoS IDs.
•
Use the QoS policy to limit the traffic rate to 2 Mbps in each direction.
Figure 28 Network diagram
GE1/0/1
Router A(CE)
Table 4 Interfaces and IP address assignment
Device
Router A
Router C
Configuration procedure
1. Configure IP addresses for each interface. (Details not shown.)
2. Configure a BGP connection on Router A.
<RouterA> system-view
[RouterA] bgp 100
[RouterA-bgp] peer 167.1.1.2 as-number 200
[RouterA-bgp] peer 167.1.1.2 connect-interface gigabitethernet 1/0/2
[RouterA-bgp] address-family ipv4
[RouterA-bgp-ipv4] import-route direct
[RouterA-bgp-ipv4] peer 167.1.1.2 enable
[RouterA-bgp-ipv4] quit
: pass
: discard
: 0 (Packets) 0 (Bytes)
Figure 28, all routers run BGP.
AS 100 AS 200
1.1.1.1/32
EBGP
GE1/0/2 GE1/0/1
Router B(PE)
Interface IP address
GE1/0/1 192.168.1.2/24
GE1/0/2 167.1.1.1/24
GE1/0/1 169.1.1.2/24
GE1/0/2 168.1.1.1/24
Loop0
BGP-VPNv4
2.2.2.2/32
OSPF
GE1/0/2 GE1/0/2
Router C(PE)
Device
Router B
Router D
101
AS 300
Loop0
EBGP
GE1/0/1 GE1/0/2
Interface IP address
GE1/0/1 167.1.1.2/24
GE1/0/2 168.1.1.2/24
GE1/0/2 169.1.1.1/24
GE1/0/1 192.168.3.2/24
GE1/0/1
Router D(CE)