Rrpp Configuration Commands; Control-Vlan - HP 7500 Series High Availability Command Reference

RRPP configuration commands

This Switch Series supports RRPP fast detection only after SD or EB cards are mounted in it.

control-vlan

Use control-vlan to configure the primary control VLAN for the current RRPP domain.
Use undo control-vlan to remove the control VLAN for the current RRPP domain.
Syntax
control-vlan vlan-id
undo control-vlan
Default
No primary control VLAN exists in the RRPP domain.
Views
RRPP domain view
Default command level
2: System level
Parameters
vlan-id: ID of the primary control VLAN for the RRPP domain, which ranges from 2 to 4093. The specified
VLAN must be a new one (not yet created).
Usage guidelines
When configuring control VLANs for an RRPP domain, you only need to configure the primary control
VLAN. The system automatically configures the secondary control VLAN, and it uses the primary control
VLAN ID plus 1 as the secondary control VLAN ID. For the control VLAN configuration to succeed, make
sure the IDs of the two control VLANs are consecutive and have not been assigned yet.
To ensure proper forwarding of RRPPDUs, do not configure the default VLAN of a port accessing an RRPP
ring as the control VLAN, or enable 802.1Q in 802.1Q (QinQ) or VLAN mapping on the control VLANs.
Before configuring RRPP rings for an RRPP domain, you can delete or modify the control VLANs
configured for the RRPP domain. However, after configuring RRPP rings for an RRPP domain, you cannot
delete or modify the control VLANs of the domain. You can only use the undo control-vlan command to
delete a control VLAN.
Examples
# Configure VLAN 100 as the primary control VLAN of RRPP domain 1. (Assume that VLAN 100 and
VLAN 101 have not been created yet.)
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
Related commands
rrpp domain
63