HP 7500 Series High Availability Command Reference page 71

--------------------------------------------------------------------------------
1 0 T
2 1 E
Table 23 Command output
Field
Flags for Node Mode
RRPP Protocol Status
Number of RRPP Domains
Domain ID
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Fast Detection Status
Fast Hello Timer
Fast Fail Timer
Ring ID
Ring Level
Node Mode
Primary/Common Port
GE1/0/3
GE1/0/3
GE1/0/4
Description
RRPP node mode:
•
M—Master node.
•
T—Transit node.
•
E—Edge node.
•
A—Assistant edge node.
RRPP protocol status:
•
Enable (globally enabled)
•
Disable (globally disabled)
Number of RRPP domains configured.
RRPP domain ID.
Control VLANs of the RRPP domain: Major and Sub.
List of VLANs protected by the RRPP domain. MSTIs are displayed here. To
get the VLANs corresponding to these MSTIs, use the display stp
region-configuration command.
Hello Timer value, in seconds.
Fail Timer value, in seconds.
Fast detection mechanism status:
•
Enable for enabled.
•
Disable for disabled.
The interval specified in milliseconds at which the master node sends
Fast-Hello packets out the primary port.
The maximum delay specified in milliseconds between the master node
sending Fast-Hello packets out the primary port and the secondary port
receiving the Fast-Hello packets from the primary port.
RRPP ring ID.
RRPP ring level:
•
0—Primary ring.
•
1—Subring.
Node mode.
•
Primary port when the node mode is master node or transit node.
•
Common port when the node mode is edge node or assistant edge
node.
•
A hyphen (-) appears when the port is not configured on the ring or the
board to which the port belongs does not start.
65
GE1/0/4
GE1/0/5
Yes
Yes