Vrrp Vrid Track - HP 7500 Series High Availability Command Reference

undo vrrp vrid virtual-router-id timer advertise
Default
The Adver_Timer is 1 second.
Views
Interface view
Default command level
2: System level
Parameters
virtual-router-id: VRRP group number, which ranges from 1 to 255.
adver-interval: Interval at which the master in the specified VRRP group sends VRRP advertisements. It
ranges from 1 to 255 seconds.
Usage guidelines
The Adver_Timer controls the interval at which the master sends VRRP packets.
Before you execute the command, create a VRRP group on an interface and configure the virtual IP
address of the VRRP group.
Routers in the same VRRP group must use the same Adver_Timer setting.
Examples
# Set the master in VRRP group 1 to send VRRP advertisements at intervals of five seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-Vlan-interface2] vrrp vrid 1 timer advertise 5
Related commands
display vrrp

vrrp vrid track

Use vrrp vrid track to associate a VRRP group with a track entry and control master switchover in the
VRRP group in response to changes (such as uplink state changes) detected by the track entry.
Use undo vrrp vrid track to remove the association between a VRRP group and a track entry. If no track
entry is specified, the association between the VRRP group and any track entry is removed.
Syntax
vrrp vrid virtual-router-id track track-entry-number [ reduced priority-reduced | switchover ]
undo vrrp vrid virtual-router-id track [ track-entry-number ]
Default
A VRRP group is not associated with any track entry.
Views
Interface view
Default command level
2: System level
109