Kyocera Ecosys P3050dn Operation Manual page 183

Disp. Backlight (Display backlight setting)
Set the backlight for the message display.
Disp. Backlight:
* On
01
02 Off
Touched
03
Error Handling (Error detection setting)
This specifies the settings for the detection methods used for duplex printing errors and for paper size and paper type errors
when the paper source is fixed.
The options available in Error Handling are as follows:
• DuplexPaperError (Duplex printing error detection setting)...4-103
• Paper Mismatch (Detection settings for paper size/type errors when the paper source is fixed)...4-104
• InsertMismatch (Action when size error occurs during paper feeding)...4-104
• MP Tray Empty (Warning when the MP tray is empty)...4-104
Error Handling:
DuplexPaperError
01
02 Paper Mismatch
03 InsertMismatch
DuplexPaperError (Duplex printing error detection setting)
If the error detection setting for duplex printing has been turned Display Error, and you attempt to print onto a paper
size and paper type that cannot be used for duplex printing, the Duplex disabled error message will be displayed and
printing will stop.
1-sided • To print onto one-side of the paper.
Display • To print onto one-side of the paper only when this message is displayed, press [OK].
Error
• Press [Cancel] to cancel the printing itself.
1
In the Device Common menu, press  or  to select Disp.
Backlight.
2
Press [OK]. The Disp. Backlight screen appears.
The list shows the following display backlight settings:
On (Standard)
Off (No backlight)
Touched (Backlight lights up when the key on the operation panel is
pressed)
3
Press  or  to select the desired backlight setting.
4
Press [OK]. The backlight setting is set and the Device Common
menu reappears.
1
In the Device Common menu, press  or  to select Error
Handling.
2
Press [OK]. The Error Handling menu screen appears.
Exit
1
In the Error Handling menu, press  or  to select
DuplexPaperError.
4-103
Note If Touched is selected, the backlight turns off again
when the panel is reset after the setting time of Auto Panel
Reset has passed or when [Logout] is pressed.
Operation Panel